![]() If you haven't done so already, thread the screws into the printed part and then back out. If you are using the square nut version of the STL, you should add these now!ĩ. Prepare your printed part: Make sure any support material has been removed. ![]() With the Prusa Mini HotEnd successfully disassembled, you are now ready to add the new mount. You should cut the cable ties holding the sleeve to the x-axis now.Ĩ. Unwrap some of the cable sleeve and place the Prusa HotEnd on the heatbed for now, we will deal with the rest of the wiring later. The whole HotEnd assembly will now be loose, so be careful.ħ. Remove the screw above the fan which holds the heatsink. Remove the screw that sits underneath the fan.Ħ. Remove the screw that connects the pinda arm to the heatsink.ĥ. Remove the arm and set it aside, you will need it later.Ĥ. Remove the screw that holds the cable management arm in place. You may have to use pliers or a wrench to get a good enough grip on the fitting.ģ. Loosen the upper fitting and remove the Bowden tube from the HotEnd. It is a good idea to keep your screws in a small container while you are working on the printer so that you don't lose them!Ģ. This will help ensure you do not strain the wires. Use the 2.5mm hex key to remove the screw holding the part cooling fan in place and then carefully twist the fan upwards as you remove it. You should also place a cloth or piece of fabric over your heat bed to give it some protection in case you drop something onto it.ġ. ![]() You should also ensure there is no filament loaded and that the printer is unplugged from the power source before starting. Move your extruder to roughly the centre of your bed and around 100mm above the build plate before starting this upgrade, this will give you easier access to the extruder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |